Aoke Cutter

The following topic describes how to configure the specified cutter. This was created based on experience and knowledge and is a recommendation only.

The Plotter/Cutter Setup dialog is dynamic according to the plotter type you select; therefore you may not see all the available commands. For more detailed information about all the available commands see Plotter/ Cutter Setup.

Plotter Cutter Format Setup

Driver Format: HPGL

General Tab

Command	Value
X (Length)	900
Y (Width)	600
Y Offset	Optional
Gap After Plotting	Optional
Minimal Plot/Cut Line	0
Bulge (Chord Error)	0.0079 in or 0.02 cm
Overcut Length	Optional
Splicing Marker Origin And Size	Optional
One Frame Only	Unchecked
Frame Advance After Last Frame	Checked
Plot/Cut Piece in One Frame	Unchecked
Order According Tools	Unchecked
Pens (Tools) According to Sizes	Unchecked
Plot Continuous	Checked

Device Tab

Command	Value
M19_For_Slit_Notch	Unchecked
M19 for Non-Slit Notch	Unchecked
Use Inch Unit	Unchecked
Cut Darts	Unchecked
No Draw	Unchecked
File Header	Unchecked
Use Built-in Font	Unchecked
(0,0) in Frame Center	Unchecked
Manual Frame Advance	Checked
Use CR/LF in Code	Unchecked
Use Initialization in File Header (<M70>/<IN>...)	Unchecked
Use Byte Offset	Unchecked
File Footer	Unchecked