Manual Cut Sequence of Internals Elements

The cutting sequence of internals elements depends on the elements tool.

By default, this order can not be changed in Optitex Mark, only in PDS.

A new INI parameter was added to enable a manual setting of the internal cut sequence.

"UseAutomaticToolPlotOrder=1" in [OptiTex Mark] section of optikad.ini

By default the value is set to 1. If set to 0, the internal elements are plotted according to the manual ordering.

The order can be changed through the Internals dialog box (Ctrl+E)

 See also:

• Marker Knowledge Base

• Marker