Opstop Command To Gerber Format

For Opstop command to work, the Stripe Adjust should be enabled and an INI parameter should be added, otherwise even if defined as Operation Stop, it will not send it to the Gerber file.

To use the opstop command:

  1. Enter the proper INI settings.

  2. Enable the Stripe Adjust.

  3. Select a piece.

  4. Invoke the Internals command.

  5. Select a button/notch.

  6. Select the Operation Stop behavior. If set to'Stop with confirmation', or 'Stop', the cutter will stop before cutting it.

 

INI Settings

In Optitex INI [OptiTex Mark] section: OpStopFollowsStripeAdjust = 1

 

 See also: